System LEDs

the eg122sn has three colored leds these are used to visualize various system information system led green sequence description off system idle flash briefly every 5 seconds system hearbeat can be activated in the advanced settings of the web configuration permanent glow the system software is initialized flash three times briefly (100ms) pause (1000ms) setup mode the device is ready for initial setup via the browser uniform flashing (1000ms) services are started uniform flashing (250ms) update or recovery is performed extra led orange sequence description off normal state flashing briefly once (100ms) device detected during automatic pairing flashing briefly once (100ms) rx channel when enocean io is visualized can be activated in the advanced settings of the web configuration controller led blue sequence description off controller idle permanent glow operating system starts permanent glow automatic pairing active uniform flashing (2000ms) system button pairing mode active flashing briefly once (100ms) tx channel when enocean io is visualized can be activated in the advanced settings of the web configuration example power supply connected all leds are off for about 15 seconds hardware is being initialized and firmware drivers are being loaded the blue led is permanently lit for about 20 seconds the operating system starts and loads the software stack the wlan network scan is visualized through the orange led the software stack is loaded the further startup process is visualized through the green led (setup mode, service start, etc ) if necessary, the blue led starts blinking as no system button has been programmed for the controller software